Installation Instructions for Fixed Water Feed System

The water feed hook-up installation should take approximately 15 minutes following the steps outlined below: Before proceeding place a small container under the work area to catch residual water.

Step 1: Turn off water shut off valve to your commode. Flush toilet to empty the water closet.

Step 2: Remove the flexible hose (Picture 1) from the base of the water closet. If there is a fixed pipe type fitting, remove it and replace it with flexible connection.

Step 3: Attach the E-Z Clean Shut off valve (Picture 2) to the base of the water closet and secure firmly. Attach the commode inlet flexible hose (Picture 3) to the bottom of the E-Z Clean shut off valve. The water feed wand hose is attached by pushing the ¼ inch hose into the quick connect fitting ( Picture 3) taking care to insert it all the way in the hole till it stops. Check to be certain it has properly seated by pulling the hose which should remain securely attached.

Step 4: Attach the other end of the ¼ inch hose to the Water Feed Wand by inserting the hose into the quick connect fitting at the end of the wand (Picture 4). When the hose stops, push harder and it will engage lock.

Step 5: Remove the cover from the water closet and slip the holder clip (Picture 4) onto the side of the water closet. Attach the Water Feed Wand to the clip. Replace the cover to the water closet and you have completed the installation.  Caution: Leak Test before Using the System                              

Schena Ostomy Technologies, Inc.

2313 Harrier Run, Naples, Florida 34105, Tel: 239 263-9957